16
5.1.10 Place the splice protector in the holder, start at outside of the
tray, (hold the splice holder with finger to prevent bending) and coil the
fibers in the tray.
1
12
5.1.11 Check whether all fibers are properly routed before placing the
cover on the tray. All fibers should be under the containment lips.
24 splice module
5.1.12 Strip the loose tubes and place 1 layer of foam around all the
tubes at 50 mm from the end of the tubes.
5.1.13 Secure all the tubes with the two tie-wraps as shown.
In case not all fibers will be installed at day 1
5.1.16 Secure the added tubes also with one tie-wrap as shown.
Preparation is the same as the first installed tubes.
5.1.14 Strip the loose tubes and place 1 layer of foam around the
tubes at 10 mm from the end of the tubes.
5.1.15 Secure all the tubes with one tie-wrap as shown.
