5
4.1.9
Open the oval port; the cutting wire can be used.
4.1.8
If the cable diameter is more than 8mm Fix the cables with the
hose clamp onto the loop bracket. Wrap a few layers of tape around
the hose clamp.
If the cable diameter is less than 8mm fix the cables with tie wraps.
•
When using cables with a diameter smaller than 12mm,bend the
sharp edges on the bottom of the bracket towards the cable and use
some tape around the bracket to protect the heatshrink.
4.1.10 Take the oval sleeve and place the packing bag that has been
opened on both sides in the oval sleeve to prevent the hotmelt inside
the sleeve from dirt and grease. Take the LCIT and bend the loose
tubes gently over it. Push the loose tubes in the sleeve. The non-coated
edge of the sleeve and the arrows should be pointed to the base of the
closure.
4.1.11 Now push the loose tubes (looped around the LCIT) in the oval
port up to the bottom of the bottom bracket.
4.1.12 Remove the LCIT and pull the cable gently in the closure.
