13
4.2.25 Slide the loop breakout device in the loopbracket and fix the
two screws. Open the oval port as described in loose tube
preparation..Take the oval sleeve and place the packing bag that has
been opened on both sides in the oval sleeve to prevent the hotmelt
inside the sleeve from dirt and grease. as discribed in loose tube
preparation.
4.2d
Twistfree fibers or limited twist (single fiber, ribbon
and compact cable sheet)
4.2.24 Divide the fibers according to the position in the loop breakout
device (fig.); in the 4 small cavities and spiral tubes (ST) directly to the
trays in a way that fibers going to the O-side and E-side of the closure
(also marked on the loop breakout device) are divided, divide also the
exchange and customer fibers (avoid unnecessary crossings). Typical a
looped fiber will be put in two spiral tubes going to the same side of the
closure (O- or E-side). Put the spiral tubes over the different bundles of
fibers and insert afterwards the spiral tube with fibers in the loop
breakout device.
4.2.26 Push the fibers in the oval port and position the loopbracket in
the bottom bracket and lock with the split pin.
