Tuttnauer AMS10-120-T, Operation And Maintenance Manual

Page: 74 / 104

9.4.3 Replacing the Drain Filter
Note:If after successive cleaning of the filter the result is not satisfactory
proceed to the replacement of the drain filter (paragraph 9.4.3 below).
Cautions!
Before proceeding, make sure that the electric cord
is disconnected and there is no pressure in the
chamber.
Use scissors to open the filter bag and not sharp
blades or pointed instrument.
Check that the new filter has not exceeded the
maximum shelf life.
Carefully un-pack the new filter and examine it for
any signs of damage.
Remove any protective packaging before inserting
the filter into place.
Carefully Insert the new filter into the housing. Do not
force.
Caution!
Make sure the autoclave is not hot before cleaning it
The DRAIN filter (1) is located inside the autoclave chamber at the bottom far
end, to reach the filter open the autoclave chamber door, remove the tray (see
below).
1. Replace the old DRAIN filter, by the new DRAIN filter (P/N:
CMT511-0048).
2. Open the autoclave chamber door, remove the tray (2), (see
below).
Page 67