Connecting
Connecting the power supply
20
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | [email protected] | www.turck.com
6.2
Connecting the device to Ethernet
For the connection to Ethernet the device has an integrated auto-crossing switch with two 4-
pole, D-coded M12 x 1-Ethernet-connectors. The maximum tightening torque is 0.6 Nm.
Fig. 10: M12 Ethernet connector
Connect the device to Ethernet according to the pin assignment below.
v
4
1
3
2
P1, P2
1 = TX +
2 = RX +
3 = TX –
4 = RX –
flange = FE
Fig. 11: Pin assignment Ethernet connectors
6.3
Connecting the power supply
NOTE
We recommend the use of pre-assembled 5-pole power supply cables,Turck type 52
(e.g. RKM52-1-RSM52). Suitable cables can be found on
.
For the connection to the power supply, the device has two 5-pin 5-pole 7/8" connectors. V1
and V2 are galvanically isolated. The maximum tightening torque is 0.8 Nm.
Fig. 12: 7/8’’ connector for connecting the supply voltage
Connect the device to the power supply according to the pin assignment shown below.
1 BK
= GND V2
2 BU
= GND V1
3 GNYE = FE
4 BN
= 24 VDC V1
5 WH
= 24 VDC V2
3
4
5
2
1
w
v
3
4
5
2
1
X1
X2
Fig. 13: Pin assignment voltage supply connectors
Connector
Function
X1
Power feed
X2
Continuation of the power to the next node
V1
System voltage: Supply voltage 1 (incl. supply of electronics)
V2
Load voltage: Power supply 2
