Operating Spanner Modules at EtherNet/IP™
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | [email protected] | www.turck.com
48
Enter a name for the spanner module.
For “Comm Format” select “Data – INT”.
Enter the desired IP Address under “IP Address” (here Ethernet/IP is mapped to port 2 of the
spanner module). Enter the “Connection Parameters” as pictured below and click “OK”.
Set the desired RPI (Requested Packet Interval) and check the “Use Unicast Connection over Eth-
erNet/IP™” check box. Click “OK”.
Go online and download the project to the controller. Set the controller to “RUN Mode”.
Fig. 46: RSLogix – settings “New Module”
Fig. 47: RSLogix – settings “Connection”
