19
• Press the
START (c2)
button
and keep it pressed until the
engine has started.
In any case do not keep the
button
(c2)
pressed for longer
than 15 seconds.
The engine oil and battery indicator lights go out and the
display shows the value (from 1 to 100) of the reference
voltage of the mortar fl ow control, in bar form and
numerical value.
If the machine does not start at the fi rst attempt, wait
30-40 seconds, press the
ON/OFF (c1)
button and then
press the
START (c2)
button again.
Attempt restarting 4-5 times at the most.
Too many attempts at starting should be avoided.
When the machine is ready to operate, the following
indications appear on the display:
The total time of operation of the machine, given in hours,
is displayed top right.
This total time is used to indicate that
“Maintenance” work should be carried out
when the scheduled intervals have elapsed.
Leave the machine idling for a few minutes in order to
warm up
(35)
.
The following indications appear on the display:
The battery voltage value is shown at the top, so that its
charge can be checked.
Dopo un tempo di circa 15 secondi sul display appaione le
seguenti indicazioni:
The following indicator lights come on:
- engine oil
(b2)
and battery
(b1)
MIN
35
MAX
Vbat: 12.5
Glow plugs heating
c2
c1
Reg: >
< 20
ProH x.x
[T: 0175]
READY
[xxxxxx]
Vbat: 12.5
Motor On: START
Summary of Contents for PRO H CL
