Turbosol PRO H CL, Instructions For Use And Maintenance Manual

Page: 17 / 54

17
• Pump setting
If you have installed a new pump, and in any before
starting a new shift it is advisable to check the setting of
the pump by carrying out the following procedure:
- Mount the pump setting device (30) with the valve
open;
- Fill-up the hopper
with water;
- Close the valve on
the pressure
setting device
(31) .
- Start the pump
by pressing the
ON/OFF (e1)
button on the control panel;
- Read the pumping pressure shown on the pressure
gauge mounted on the outlet collector of the mortar
pump
(32) .
The values must correspond, indicatively to the
ones shown in the chart.
- After a few seconds (ab. 10 seconds) stop the pump:
you can now read the pump sealing pressure on the
pressure gauge. This fi gure must be at least half of the
pressure that you read previously when working with
material.
C
ORRECT PRESSURE VALUES
(indicative)
PUMP HOSE LENGHT UP TO
40 m 50 m 60 m
60.12* 8 bar 10 bar 12 bar
*
setting value.
For the pump 60.12 Plus (optional) check that the pressure
reaches 8 ÷ 0 bars, in case you can not reach the before
mentioned pressure you need to change the rotor and
stator pump.
If the setting pressure values are different than the ones
shown on this chart you must act on the nuts placed on
the pump clamp
(33)
- Clockwise: the setting pressure increases;
- Counter clockwise: the setting pressure decreases.
Repeat the setting operation until you get the regular
pressure values.
Remote the pump setting device
(30) and connect the
delivery hose.
If you cannot set the pump it is necessary to change the
stator and eventual the screw as well.
31
30
32
33
e1