10
TurboLock TL - 201
Step 2.
Remove the battery cover from the inside section of the lock and adjust the L/R Switch and thumb turn as needed.
3.2 Main Installation
Step 1.
Start with the outside section. Feed the power cables under the
latch and thread the latch pin and two of the pegs through the
latch. The third and highest peg should be above the latch. If
needed, have someone hold the door itself or hold the outside
section flat against the front of the door.
(Fig. 4)
•
Before threading the latch pin into the silver center part
and make sure the key is turned so it can easily be removed
from the keyhole. Make sure the latch pin is horizontal when
inserting.
•
It’s highly recommended to leave the door open and keep the keys
in the lock during installation.
•
Make sure the power cables are under the latch.
Latch on the right
L/R switch pushed to
R side + thumb turn
horizontal
Latch on the left
L/R switch pushed to
L side + thumb turn
vertical
L R
L R
L R
L R
Inside Section
Inside Section
2
3/4
” 2
3/8
”
Highest Peg
(Fig. 4)
Silicone Backing
Latch Pin
