18
TurboLock TL - 201
Step 3.
Connect the cables to the connectors. Make sure the lines and notches from
each connector are on the same side.
Step 4.
Check that the lock is set for the correct orientation. If needed, adjust the
switch and thumb turn according to the orientation needed for your door.
Refer to the images on page 16.
Step 5.
Fit the inside section over the plate. Make sure to thread the latch pin into silver center part and tuck the cords away
from the lowest screw hole.
(Fig. 12)
If needed, tuck the cables inside the door hole.
Before threading the latch pin into the silver center part , make sure the key is turned so it can easily be
removed from the keyhole.
Step 6.
With the inside section flat against the back of the door, use the 4x inside screws to fasten it to the back of the door.
Note the placements for the different sized screws.
(Fig. 13)
Make sure all screws are tightened.
(Fig. 12)
(Fig. 13)
Silver Center Part
Latch Pin