TurboLock TL - 100 15
Step 3.
Insert the latch into the hole and check it. The latch’s plate should sit flush against the edge of the door. If
there’s too much space behind the latch or if it’s sticking out of the door, the latch should be adjusted. If the
latch needs adjusted, move to Step 4. If it doesn’t need adjusted, skip to Step 5.
Step 4.
Hold the front of the latch and the square opening from both sides, pull or push to extend or retract the latch’s
end as needed.
(Fig. 17)
Insert the latch back into the door.
Step 5.
Check the latch’s bolt and make sure the rounded side faces in or out according to the way the door swings.
(Fig. 18a & 18b)
Step 6.
Add 2x latch screws and use a screwdriver to secure them.
Part 3 Creating a Mortise & Installing the Strike
Step 1.
Push the door until nearly closed and check where the latch’s bolt
touches the frame.
Step 2.
First, use a pencil to mark the horizontal center of the latch on the
door frame.
(Fig. 17)
(Fig. 19)
(Fig. 18a)
Rounded
side
(Fig. 18b)
Rounded
side
