Tube-Line TL5500 2004, Owner'S Manual

Page: 57 / 71

3 3/8 x 1 Bolts, nut lockwasher
4 Spool Holder
Model TL5500 & TL6500
Re: Mounting Accessories (year 2003)
Remote Package consists of Pause –Cycle stop, Start – start wrap cycle,
Steering – Right/Left
1: Installing Remote Package
Bolt receiver assembly to inside rear right of control box with connector plug at bottom. Thread the two long loose wires
through the rear of control box. Tape these wires to some of the other wires, so they can not get caught in the machinery, as
these wires are the antenna wires for the receivers. Remove the jumper between term #8 and #10. Plug the connector together at
the bottom of the panel.
2: To align the frequency from the transmitter or the “hand unit” push the remote
button on transmitter and at the same time push “smart button” on the receiver inside the gray
control panel, green indicator light will flash to indicate that receiver has locked on. Release the
remote switch. Do the same for all the buttons on control. If for any reason you want to change
the arrangement of the buttons, you will have to erase the code in the receiver. To erase the
code press the “smart button” and hold in until the green indicator light turns off (about 6
seconds). All codes the receiver has learned are erased. You can then redo the aligning of the
buttons as you prefer. The white arrows show the default relationship between the receiver and
the hand unit.
3: When using the remote start of ram, unplug the wire from the switch at the table trigger to disable the switch.
Secure the end of wire somewhere so it does not get tangled in the steering of the wrapper, make sure the plug will not short out
to the frame.
Transmitter
Stop Start Left Right