Tube-Line TL5500 2004, Owner'S Manual

Page: 3 / 71

New for 2003
Remote Control
The new remote control looks the same as the previous models looked; however instead of stopping the
engine it only interrupts the wrap cycle in automatic mode only.
1. With the remote control; by pressing the start switch on the hand held unit the wrap cycle will be started and
will go through the complete cycle and stop at the end of the stroke.
2. The cycle can be interrupted at any time during the cycle.
However:
When using the table trigger to start the cycle: the stop button will only stop the cycle
when and if the bale is no longer on the trigger switch.
Notice!
When a bale is on the table trigger the
Stop button will have to be held in until the operator can switch the “auto/man” to “man”. To restart the cycle if the
bale still sits on the trigger turn the “auto/man” switch to “auto” and the cycle will finish.
When the stop button is pushed with no bale on the trigger or with the trigger disconnected, the cycle will
stop without the button being held in. To resume the cycle the start button can be pushed in.
Caution
STOP ENGINE !!
Before Attempting to change or replace Plastic Film roll
Before Boosting the battery
make sure the “auto/man” switch is on “man” as it is possible to blow the trace off
the circuit board on the remote receiver if the switch is turned to “auto” and will VOID the Warranty.