Tube-Line TL5500 2004, Owner'S Manual

Page: 52 / 71

Film Sensor
Installation
This machine is pre-wired for film switch. To
install, locate 2 wire plug underneath the table
between the bale spears. Remove the plug, and
plug film switch into it.
Install toggle switch into the bottom of the
control panel as shown. With this switch the film
sensor can be disabled in the “auto” position.
Notice in “man” the sensor and the
safety doors do not work.
Adjust the wire arm with no plastic in the
machine, make sure the wire does not interfere
with the plastic roll assy. When plastic is in the
machine it will hold the wire up causing the
switch to close. Make sure the switch closes with
the wire parallel to the bale spears. Wire can be
shortened to suit your needs. The switch bracket
can also be adjusted back and forth so only one
layer of plastic holds the wire up, if more than
one layer contacts the plastic then the unbroken
roll is holding it in place and defeat’s the sensor.
Wire adjustment. Wire
should stick through and
touch the top of bracket to
keep other end from
dropping down too far
Adjusting Bolt
Toggle Switch in
Control Panel
Film Sensor
Switch
Plug Underneath Table
Door Switch
Toggle Switch
Brown & Yellow
connected wires laying in
bottom of panel
Red to #10
Green to #9
Locate the brown and
Yellow (
pre-wired) and
connected together and
laying in the bottom of the
control panel. Remove the
connector and fasten to
toggle switch, this is not
polarity sensitive.