Setting up Parameters via the Keypad
Restoring Default Factory Settings
EVM Series User Manual
34
Setting Analog-Out
1. From the setup screen, select
Aux I/O
and press
Enter
.
2. Press
▲/▼
Arrows
to select
Analog-Out
and press
Enter
.
3. To enable or disable, press
Enter
when
Analog-out
is selected and press
▲/▼
Arrows
to
change the setting. Press
Enter
to move back to the 1
st
column.
4. To select a sensor, ensure
Sensor
is selected and press
Enter
. Then, press
▲/▼
Arrows
to
page through the selection list. Once the appropriate sensor is selected, press
Enter
.
5. To return to the start screen, press
On/Off/Esc
twice.
Disable/Enable Analog-out field
Select a Sensor
Figure 3-16: Analog-Out screen
Restoring Default Factory Settings
The EVM is equipped to restore all factory settings and factory calibration settings via the Defaults
screen.
NOTE
: Dew Point and Air Velocity are not user calibrated and therefore, not listed in the restore
factory calibration screen.
1.
In the Setup menu, press
▲/▼
Arrows
until
Defaults
is selected (or highlighted).
2.
Press
Enter
(to open the screen).
Restoring Default settings
Select either (or both) to restore all
factory cals/settings.
Figure 3-17: Defaults screen (restoring factory settings)
