Setting up Parameters via the Keypad
PID Sensor Setup
EVM Series User Manual
25
4.
Optional
: To view the Estimated Run Time, select this field (by pressing
▲
/
▼
Arrows
) and press
Enter
. The estimated run time screen will appear.
NOTE
: To extend the logging time, turn a logged measurement(s) to “Off” and/or change the
log interval. Then, re-check the estimated run time.
Estimated run time
**
NOTE
: To increase the total duration, log
only one or two measurements
and/or change the log interval.
Figure 3-6: Estimated run time for logging screen
5. Press
On/Off/Esc
repeatedly to return to the Start screen.
PID Sensor Setup
For best PID testing results, it is recommended to add a correction factor to the relevant VOC you intend
to measure. Refer to the PID correction factors table in
for more details.
Additionally, the PID setup screen is used to set the ppb zero cal to either enabled or disabled
(if applicable).
