TSI Incorporated SIDEPAK AM510, User Manual

Page: 31 / 74

Operation 23
If 30 seconds elapse without a key being pressed, the display
reverts back to LOGGING DATA and shows the last data value
recorded.
To stop a test, press the

or PAGE key. The AM510 will ask you
to confirm that you want to stop the test or not, while data logging
continues. If you choose to continue (Return), there will be no
break in the data.
If you stop a test in progress, the AM510 will display Data
Logging Stop Data Saved and switch to the Statistics Menu so
you can view the results of that test.
If you stop a test before any data points have been recorded, the
display will show Data Logging Aborted and wait for you to
acknowledge by pressing

. It will then return to Survey Mode.
An example of when this may happen is if the logging interval is
set to 1 minute and the test is stopped before the first data point
is recorded.
Programming Prog 1 and Prog 2 with TrakPro Software
Use Prog 1 or Prog 2 modes for unattended recording and
setting user protocols. With Prog 1 and Prog 2 modes you
can set the start date, start time, test length, logging interval,
number of tests and the time delay between tests. All or
selected parameters can be set.
To program a protocol for Prog 1 or Prog 2 mode:
1. Make sure the SidePak monitor is connected to the
computer and turned on.
2. Select Logging Setup from the Instrument Setup
menu. TrakPro software retrieves the current settings for
Prog 1 and Prog 2 modes from the SidePak monitor and
displays them in the following dialog: