Tryton TMGK500, Operating Instruction

Page: 6 / 40

ź
Switch the power tool on. The screw begins to be driven into the result in damage to the motor.
material until the preset depth is obtained. The drive switches off; the
chuck stops turning. Check the driving depth and re-adjust, if
necessary.
ź
To undo screws set the feature «left rotation direction» using rotation - check whether the power cord ( 10 ) is correctly plugged in and the
electric power outlet is energized;
direction selector ( 6 ) and remove the driving depth limiter ( 4 ), by
sliding it forwards.
- check condition of carbon brushes and replace them if necessary.
Once the driving depth is adjusted, it is possible to re-install driving
depth limiter (
4 ).
- if the defect persists, the tool fails to work despite of voltage presence
n
Belt clip
and carbon brushes are in good condition, hand the tool over for repair
to an authorized workshop to the address specified
in your warranty
By using the clip ( 5 ) it is possible to hang the power tool on a belt. Thanks
card.
to this both hands are free, and the power tool is still within your range.
MANUFACTURER:
PROFIX Ltd.,
34 Marywilska Street,
03-228 Warsaw, POLAND.
This appliance is in conformity with national and European standards as
well as with general safety guidelines.
n
Cleaning
Any repairs are allowed to be carried out exclusively by qualified staff
with use of original spare parts.
PROTECTION OF THE ENVIRONMENT:
To provide safe and efficient operation, the power tool and its venting
The symbol nearby denotes that old equipment must
holes should be kept clean.
never be thrown away together with other waste (with the
Clean the power tool immediately after each use. Its outer plastic
penalty of a fine). Hazardous components of electronic
components can be cleaned with a slightly wet cloth and soft cleaning
equipment may adversely affect the natural environment and
agent. NEVER use any solvents; as it may result in damage to plastic parts
human health.
of the power tool. Protect the power tool against water penetration.
Each household may contribute to the recovery and reuse (recycling) of
Once cleaned allow it to dry.
old machinery and equipment. Both in Poland and Europe a system for
recovery of used equipment either exists or is being created. The system
obliges all organizations that sell such equipment to collect the used
Store and transport the tool in its transport box to protect it against
machinery and appliances. Moreover, general purpose collecting points
humidity, dust penetration and small objects; remember to protect its
for such equipment are available. ventilation openings. Small objects after getting into the casing can
NOTE! Carbon brushes can be replaced only by competent electricians.
STORAGE AND MAINTENANCE:
Co. The tool in principle does not require any special maintenance or service.
The tool must be stored in a place that is not accessible to children and
must be kept clean and protected from moisture and dust. The storage
conditions should prevent potential mechanical damage and impact of
the weather conditions.
NOTE! Prior to any cleaning or maintenance always unplug the driver from
the mains socket.
NOTE:
TRANSPORTATION:
TROUBLESHOOTING:
The electric tool fails to switch on or works with breaks:
6
The policy of the PROFIX company consists in permanent improvements of the offered products and therefore the company
reserves the right to make amendments to the product specification without a prior notice. The images included into the
operation manual are only of the exemplary nature and may slightly differ from actual appearance of the device purchased.
This instruction manual is protected by copyright. Copying it without the written consent of PROFIX Co. Ltd. is prohibited.