E459EN_05.DOC
Maintenance
23
Disassembling the blade
1. Open locking mechanism (15).
2. Rotate supporting body (1) by 45°.
3. Pull supporting body (1) out towards the bottom.
4. Rotate ram (4) by 180° and pull it out towards the bottom.
Cleaning the tool
Loosen the clamping screw (2) and remove the blade (3).
Clean the ram (4).
Mounting the blade
1. Screw new blade (3) tightly to the ram (4) with the small screw
(2) (tightening torque 9 Nm).
2. Insert cleaned ram (4) into the ram receptacle and lock with a
180° turn.
3. Mount the carrier (1).
4. Close locking mechanism (15).
5. Place grease nipple laterally on the carrier using a grease gun
"F" with lubricating grease "G1" TRUMPF Order No. 139440.
Note
Use only original TRUMPF replacement parts.
5.2 Replacing carbon brushes
The motor comes to a standstill when the carbon brushes are worn
out.
Have the carbon brushes checked and replaced as needed by
a trained technician.
Note
Only use original replacement parts and take note of the
information on the rating plate.
