5.
Maintenance
Electrical voltage! Risk of fatal injury due to electric shock.
Ø
Remove the plug from the plug socket before undertaking
any maintenance work on the machine.
Risk of injury due to incorrect repair work
Machine does not work properly.
Ø
Maintenance may be carried out by trained specialist techni-
cians only.
Damage to property caused by blunt tools.
Machine overload.
Ø
Check the cutting edge of the cutting tool for wear every
hour. Sharp cutting tools provide good cutting performance
and are easier on the machine. Replace the cutting tool
promptly.
Maintenance point
Interval
Procedure
Recommended lubri-
cants
Cutting tool
Regrind/replace as needed.
Lubricate upon tool change.
-
-
Cutting tool guide
Lubricate every 50 m.
Lubricate upon tool change.
Re-lubricate with a grease
gun.
Lubricating grease
"G1"
Wear plate
Turn if necessary.
Change as needed.
-
-
Pressure die
Clean as needed.
-
-
Ventilation slots
Clean as needed.
Motor
Approx. every 300 operating
hours.
Change the carbon brushes.
-
Gearbox and gear
head
After 300 operating hours,
arrange for a trained specialist
to relubricate or to replace the
lubricating grease.
-
Lubricating grease
"G1"
Maintenance positions and intervals
Tab. 7
5.1
Regrinding cutting tool
The aluminum cutting tools and heavy-duty cutting tools are
ground at an angle on the grinding face. Observe the corre-
sponding regrinding diagram
(see "Tab. 4", pg. 10)
.
E543EN_06
Maintenance
17
DANGER
WARNING
CAUTION
