True-Surface Vibe V, Owner'S Manual

Page: 85 / 88

85
17. Install the short key and 2” pulley. Then install the snap ring included in the groove closest to the pulley.
Pull the pulley up tight to this snap ring, and then tighten the set screw.
18. Lightly anti-seize the dimpled area on the shaft, then install the outboard eccentric weight marked “A”
(31P-VR-003A) – line up the roman numeral V with the line on the end of the shaft. Install another snap
ring in the last groove on the shaft. You should be able to leave the ball spring plunger in its set position to
install the weight. The ball spring plunger is the screw that is in line with number V. Now, tighten the set
screw opposite the ball spring plunger.
19. Install your new key (H-1025) and 5” pulley (37P-7100), line it up with your 2” pulley (37P-1024), and
tighten the set screw (H-6012) – when lined up with the 2” pulley, the hub of the 5” pulley will probably
rest against the bearing (37P-7102). Next, reinstall the belt (37P-7121).
20. Install the black belt guard (31P-VR7002-1) included with the kit.
21. On the other end of the shaft, install a snap ring (37P-1014) in the groove closest to the hub. Lightly anti-
seize the dimpled area of the shaft, then install the outboard eccentric weight (31P-VR-003B) marked “B”.
Line up roman numeral V with the line on the end of the shaft, then tighten the set screw opposite the ball
spring plunger. Install another snap ring in the last groove on the shaft.
22. Install the eccentric shaft cover (31P-VR-002) included with the two 5/16” x ½” screws (H-V8004) and
lock washers (H-1013) included.
23.
Repeat this process for the remaining two units.