True-Surface Vibe V, Owner'S Manual

Page: 57 / 88

57
John Deere 2500 Motor Flange Alignment
For QA-5 & Angled UpStop Installation
1. Using the numbers for reference, units are supplied to fit all JD2500 greens-mowers with the 30A-7255
hitch assembly (Item 1).
2. Items 2,4,6,7,8 are duplicated for each side of the hitch.
3. To assemble this hitch, you will start with the frame (30A-7050W) and slide one of the 31P-7805 into the
front hole. Install H-1081 into the other 31p-7805 using blue Loctite. You will want to install R-7253W
using H-7255C to center it in the hitch and tightening 31P-7805 to secure it in place.
4. After installing 31p-1083 in the end of 31P-V7806L & 31P-V7806R and installing H-1082 with the set
screw lining up with the hole in 31P-1083, these will be ready to be installed onto 31P-7805.
5. 31P-V7806L & 31P-V7806R are directional and need to be installed to when down, the 31P-1083 is
touching the hood in the rear of the roller near the 5” roller drum.
6. Once in position you may tighten down the set screws in the V1082 and this will complete the steps of
installing your upstops.
QA-5 Motor Flange Position
If you have a greensmower equipped with QA-5 cutting reels, the motor flange will need to be installed as
follows:
Note, if an older unit is being upgraded, the flange simply rotates from a position where the open
notches are horizontal (3 and 9 O’clock) to a pair of tapped holes in this position.
1.
Fully threaded bolts (Item C) and threaded into the back of flange (Item D) with thread-locker and
tightened. This creates mounting studs for the motor.
2.
Install the motor flange (Item D) with the four flat-head screws (Item F) so that the newly installed studs
are horizontal.
3.
Use the female coupler (Item A) to make the connection between the motor shaft and roller shaft.
4.
Use the flange nuts (Item E) to secure the motor.
Hydraulic Motor Mounting Configurations
John Deere 2500, John Deere 2500 Electric, John Deere Quick Adjust (QA5)
1. Remove the factory installed motor mounting hardware from the rolling unit
2. Install the motor mount adapter (37P-7036-3), and secure it with four 5/16 x 1 ¾ flat head screws (H-1146).