9
Select-A-Vibe
TM
Dial Introduction
The True-Surface
®
VIBE
TM
Vibratory Greens Rolling System allows flexibility with the
new Select-A-Vibe
TM
dial. VIBE
TM
owners now have the ability to experiment with a
variety of vibration settings, hydraulic motor/engine speeds, and ground speeds – all of which
will affect your greens’ end-results. Turfline, Inc. created the Select-A-Vibe
TM
to produce
smooth, healthy, consistent greens by controlling various conditions through its five levels of
vibration.
You can now select your level of vibration with a simple click! Set the dial at setting number
1 for the least vibration, and increase your energy all the way to setting number 5. Simply follow the eight easy
steps on the next page.
NOTE:
Make sure the indicators are aligned at the same setting for each end to maintain even vibration across the
roller length.
Make sure to tighten the set screw after each adjustment.
The ball spring plunger is set and secured at the factory setting and requires no further adjustment, nor does
it need to be loosened to adjust the eccentrics. Should these eccentrics need to be removed for other
services, be sure they are returned to the correct end of the shaft from where they were removed.
Select-A-Vibe
TM
Adjustment Procedure:
For the Belt Guard Side:
Insert 3/16 L-Key allen wrench into the end of the shaft through the center slot on end
of belt guard.
Rotate the shaft with the L-Key to bring eccentric set screw into view through top slots.
Insert 3/16 T-handle key into eccentric set screw and loosen 1/4-1/2 turn. This set
screw is aligned with the “1” on the eccentric dial. The set screw aligned at the “5” on
the dial is a preset ball plunger and should NOT be moved.
While holding the T-handle in the set screw to prevent the eccentric from rotating,
rotate the shaft with the L-Key to desired setting (you will feel the ball plunger
“click” in and out of the shaft detents);
Tighten eccentric set screw and remove tools.
Use the same procedure for the hydraulic motor side of the roller.
NOTE: Make sure
both
eccentrics are at the same setting.
Hydraulic Motor Side B
Belt Guard Side A
Eccentric set at setting 3
Eccentric set at setting 3
Note: Setting 1 is the lowest setting, and setting 5 is the highest setting available.
Summary of Contents for Vibe V
