Press and hold the [Setting] button, then press the [Gear Po] or [Gear
Position -] button to set the sensing distance.
Press the < [Gear Position -] button to decrease the sensing distance.
Press the > [Gear Po] button to increase the sensing distance.
The
[Gear Position Indicator Light] button will display the current operating
direction.
The sensing distance has five gear positions I, II, III, IV, and V. If it is out of gear position,
the machine responds with two beeps showing the operation is invalid (the correct
operation has only one beep).
Fresh Water Replacement
Please use this function to replace the water inside the bowl first when you do not use the
toilet for a long time. It’s normal that water drains under the baffle when the fresh water is
replaced.
Long press the [Flush] button to start this function. It will stop automatically after it’s
completed.
Press the [Stop] button if you wish to stop this function.
Self-Cleaning Wand
When the user is leaving the seat, long press the [Rear Wash] button on the toilet. The
spray wand will then extend and water will come out.
Automatic Flush
Press and hold the [Setting] button, then press the [Flush] button to turn this function
on/off. When the function is turned on, it will respond with a short beeping sound. When
you turn it off, it will respond with a long beeping sound.
The toilet flushes automatically only in the Automatic Flush Mode. The specific operation
is shown in the following illustration:
Summary of Contents for 836092
Page 1: ...INSTRUCTION MANUAL G2ETBCERN 12 WH GANZA II...
Page 7: ...Electronic Bidet Side Buttons...
Page 23: ......