5
GB
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tool’s operation. If damaged, have the power tool
repaired before use.
Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed.
Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
Safety Instructions / Assembly
ASSEMBLY
We recommend the wheels are fitted to the rear legs of
the series 2000 Workcentre (see mounting holes). Tighten
the vibration proof Nyloc self-locking nuts firmly, ensuring
they are free to pivot and spin.
Step 1 (Fig.1)
Attach the Side Plates (5) to the lower mounting holes as
shown. Use the M6 x 45 Bolts (6), M6 Washers (10), and
Nyloc Nuts (9).
Step 2 (Fig.1)
Fasten the Locking Levers (3) to the U-brackets (4) using
the M6 x 16 Hex Bolts (8) and nuts.
Step 3 (Fig.1)
Insert the Wheel Bushes (2) into the arbor of each Wheel
(1).
Step 4 (Fig.2)
Bolt the end of each locking lever to the top hole in each
leg using M6 x 45 Hex Bolts (6) M6 Washers (10) and M6
Nyloc Nut (9).
Step 5 (Fig.2)
Place the wheel between the side plates, and fit the
U-bracket over the top. Fasten each wheel into position
using the longer M6 x 50 Hex Bolts (7) and M6 Nyloc Nuts
(9).
Operating the wheels
To engage the wheels, lift the leg slightly, and push down
on the locking lever tab with your foot. The wheel should
swing down and lock (Fig.3). Repeat at the other leg.
Reverse this action to retract the wheels. (Fig.4)
Using the Wheels
With the wheels engaged, lift the opposite end to move
the Workcentre. It is generally easier to pull rather than
push the Workcentre - especially on lawns, sandy soil,
uneven ground and steps.
ENGAGE THE WHEELS FOR
TRANSPORTATION PURPOSES ONLY.
Push the Workcente legs outwards after transportation to
ensure stability. The wheels must be retracted when the
Workcentre is in use.
330020_Z1MANPRO1.indd 5
09/08/2012 12:09
