Trinity Highway INGAL SS180 M, Assembly Manual

Page: 28 / 65

trinityhighway.com 27 Revision A November 2019
5) Adjust the Height and Levelness of the System Frame
Verify that the System Frame is 305mm ± 25 mm from the ground at the front and rear of
the system. It may be necessary to add shims to the Socket Hitches in order to adjust
the levelness of the Cartridge (Figure 28).
SOCKET HITCH
ADD OR REMOVE SHIMS AS
NECESSARY TO LEVEL SYSTEM
305 mm ± 25 mm
↑
↓
Figure 28
6) Verify Position of Hydraulic / Electrical Lines
Check the location of all the hydraulic and electrical lines to make sure they will not be
damaged during the folding and unfolding of the system.
7) Check System Lights for Proper Operation
Verify that all the turn / stop / tail / lights are working properly and replace all non-working
light assemblies .
There are two light circuits on the TMA. Verify both circuits are operational.
Raise the system to folded position and verify secondary lights are working.
With the system unfolded, lights on the Impact Face and Mid Frame will be on.
With the system folded, the lights on the Mid Frame will be on and the lights on the Impact
Face will be off.
8) Final check
Each fastener is in place and properly tightened.
9) Ready to Use
The system is now ready for service.