Trinity Highway INGAL SS180 M, Assembly Manual

Page: 18 / 65

trinityhighway.com 17 Revision A November 2019
7) Adjust the Height of the System Frame
Verify that the system frame is 305mm ± 25 mm from the ground at the rear of the system. It may
be necessary to add shims to the Socket Hitch in order to level the Frame (Figures 3 & 12).
8) Connect the Lights and Controls
Locate the female TMA Socket Connector in a convenient location on the truck so that lifting or
lowering the TMA will not damage the electrical cable. Make sure that the electrical cord on the
TMA can reach this location.
For support vehicles with combined tail and clearance lights, connect a jumper between pins 2 and
6 on the backside of the male TMA plug connector (VIEW A-A and Figure 14). Connect the
7-pin plug to the socket on the truck.
The truck battery must be of the proper voltage. The SS180 ® M is available in 12 and 24 volt
versions. Be sure the system and truck are compatible. Use standard safety practices when
attaching the battery cables. Attach positive terminal first when connecting and remove the
negative cable first when disconnecting the battery. Do not run the battery cables around sharp
corners, metal work, or in other areas that could pinch or cut the cables. Connect the battery cable
to the pump motor. Consult the Hydraulic Assembly drawing package.
Caution: For over-current protection, the positive cable lead coming off the
truck battery should be protected with a 70 amp fuse or circuit breaker within
450mm of the truck battery.
The controls at the rear of the truck are mounted to both sides of the Support Frame. Securely
fasten cable ties to secure any loose wiring to the SS180
®
M frame. Mount the cab switch box
inside the cab within easy reach of the driver and plug in the cab switch box at the mating connector
of the TMA.
VIEW A-A
A
A
Figure 14