1440 Ferris Place Bronx NY 10461
Tel:718-829-2332 Fax:718-829-6405
e-mail: [email protected]
www.trineonline.com
CLOSET LIGHT INSTALLATION
Your switch is ready to install. Simply attach the enclosed lead wires to the tabs that
project from the rear of the switch. Then attach one black switch wire to the black
house power lead. Attach the other black switch wire to the black lead going to the
light. Attach the white house power wire to the white wire that goes to the light. Attach
the bare ground wire to the box, using one of the screws, or direct to conduit, if used.
* Insulate all connections with wire nuts or tape approved by local codes.
The door switch can be mounted to the switch case with the
2 flat head screws (supplied).
In the event that the light stays on when the door is closed
for products 340 and 342, simply rotate the faceplate to
adjust the position of the switch. Remove the switch from
the cover plate and reverse the plate and re-insert the
switch.
Secure the switch box in position using 4 screws or nails.
Bring the Romex or BX cable to the case and secure to any
of the four knockouts using BX or Romex connectors
approved by local codes. To ensure mounting, staple the
Romex or BX cables to the wall studs within 6” of the switch
case.
©2004
TRINE MODEL 340
1 1/2"
4"
3 9/32"
Button
Diameter
5/16"
3"
1/16"
9/16"
1 1/2"
1 3/8"
Summary of Contents for 4100 Electric Strike
Page 25: ......
