Trillium WSP-6, Installation, Operation & Maintenance Instructions Manual, Page: 9 / 73

WSP™
DATA SHEET WSP™ SELF-PRIMER PUMPS WSP-D300_6
Rev. 3 01/09/20
© 2019 The Factory
9
YOUR PUMP HAS BEEN ENGINEERED TO PUMP LIQUIDS THAT CONTAIN SOLIDS OR
SLURRIES. AT NO TIME SHOULD THE LIQUID BE VOLATILE, CORROSIVE, OR
COMBUSTIBLE. FAILURE TO DO SO COULD DAMAGE THE PUMP OR RESULT IN
INJURY.
AFTER THE PUMP CASING HAS BEEN FILLED, REINSTALL AND TIGHTEN THE FILL
PLUG. FAILURE TO OPERATE THE PUMP WITHOUT ALL CONNECTION PIPING
SECURELY INSTALLED COULD CAUSE LIQUID IN THE PUMP TO BE FORCED OUT
UNDER PRESSURE AND MAY RESULT IN INJURY.
PRIOR TO WORKING ON THIS PUMP, ALWAYS LOCK OUT OR DISCONNECT THE
PUMP FROM ITS POWER SOURCE. IT MUST REMAIN INOPERABLE DURING REPAIRS.
NO PERSON SHOULD ATTEMPT TO OPEN OR SERVICE THIS PUMP BEFORE
BECOMING THOROUGHLY FAMILIAR WITH ALL THE PROCEDURES OUTLINED
IN THIS MANUAL.
1. PLEASE STUDY THESE INSTRUCTIONS CAREFULLY.
2. WHEN PERFORMING EQUIPMENT MAINTENANCE, THE EQUIPMENT
ELECTRICAL SERVICE MUST BE LOCKED OUT WITH AN APPROVED
LOCKOUT AND KEY.
3. IF THE PUMP HAS OVERHEATED, ALLOW SUFFICIENT TIME FOR THE
PUMP TO COMPLETELY COOL BEFORE ATTEMPTING TO OPEN OR
SERVICE THE PUMP.
4. CAREFULLY CHECK THE TEMPERATURES BEFORE OPENING ANY
COVERS, PLATES, OR PLUGS.
5. CLOSE THE SUCTION AND DISCHARGE VALVES.
6. CAREFULLY AND SLOWLY VENT THE PUMP.