WSP™
DATA SHEET
WSP™ SELF-PRIMER PUMPS
WSP-D300_6
Rev. 3
01/09/20
© 2019 The Factory
22
Figure 4
Take off the stationary element and the seat with a pair of stiff wires that have hooks
on their ends, or remove the hardware then pull the sealplate and gasket from the
bearing housing.
With the sealplate on a level surface, impeller side down, use a wooden dowel or
other appropriate tool to press the backside of the stationary seat until both the seat
and the O-rings are loose enough to remove then take out the shaft sleeve O-ring.
When no additional disassembly is needed, refer to Section IV. Part H. INSTALLING
THE SEAL.
F. REMOVING & DISASSEMBLING THE SHAFT & BEARING
The bearing housing should not need to be taken apart if the pump has been
correctly operated and maintained. If there is evidence of damage or wear, then
disassemble the shaft and bearings.
DISASSEMBLY OF THE SHAFT AND BEARING IS NOT RECOMMENDED IN THE FIELD.
PERFORM THESE OPERATIONS ONLY IN A PROPERLY EQUIPPED SHOP BY
QUALIFIED TECHNICIANS.
Summary of Contents for WSP-6
