Trillium WSP-6, Installation, Operation & Maintenance Instructions Manual, Page: 41 / 73

WSP™
DATA SHEET WSP™ SELF-PRIMER PUMPS WSP-D300_6
Rev. 3 01/09/20
© 2019 The Factory
41
4. Have you paid extra attention to the direction of rotation indicated on
your pump? Are you sure the pump shaft rotates counter-clockwise
when facing the impeller?
THIS PUMP SHOULD ONLY BE OPERATED IN THE DIRECTION SHOWN ON THE
ARROW ON THE PUMP BODY AND ON ANY ACCOMPANYING DECALS.
5. Have you determined the lubricant levels and lubricated it they are
low? Have you followed all the steps in Section F., LUBRICATION?
6. Have you stored the pump or its power source for more than 12-
months? If so, did you check to be sure the components or lubricants
have not exceeded their maximum life span? If they have, you must
replace them to maintain your pump’s service life.
When you complete this inspection, anything that does not appear to
be normal requires you to contact your local WSP™ distributor or the
factory for repair or the updating policy. If you determine the life span
of either the pump or its power source has been exceeded, contact
your local WSP™ distributor or the factory for repair or the updating
policy. If the pump fails inspection, do
not
put it into service until you
have resolved any problems.
C.
PUMP POSITIONING
1. Lifting
Inspect the shipping tag on your pump unit’s packing for accurate
weight to be sure the lifting equipment you use will have adequate
capacity. Pump weights will differ depending on the type of drive and
mounting used.
Before lifting existing units, drain and remove all currently installed
equipment on the pump. This includes all discharge and suction
hoses and any piping currently in place.
SERIOUS DAMAGE COULD OCCUR TO THE PUMP ASSEMBLY IF BOTH LIFTING EYES
ARE NOT UTILIZED DURING LIFTING AND MOVEMENT OF THE UNIT. ONLY LIFT THE
PUMP WITH THE LIFTING EYES.