Trillium WSP-6, Installation, Operation & Maintenance Instructions Manual, Page: 8 / 73

WSP™
DATA SHEET WSP™ SELF-PRIMER PUMPS WSP-D300_6
Rev. 3 01/09/20
© 2019 The Factory
8
DO NOT OPERATE PUMP WITH BOTH SUCTION AND DISCHARGE VALVES CLOSED
OR WITH SUCTION OR DISCHARGE BLOCKED BY CLOGGING – THIS COULD CAUSE
DAMAGE AND IS DANGEROUS. THESE PUMPS ARE TO BE USED FOR LIQUID
SERVICE ONLY. EXCESSIVE PRESSURE CAN CAUSE MALFUNCTION LEADING TO
INJURY.
PUMP LIFTING EYES ON THE SELF-PRIMING PUMP ARE ONLY DESIGNED TO
HANDLE THE WEIGHT OF THE BARE PUMP. BEFORE LIFTING, ENSURE THAT
ALL SUCTION AND DISCHARGE HOSES AND PIPING HAVE BEEN REMOVED
FROM THE PUMP, AND THE PUMP IS FREE FROM ANY BASE OR DRIVER.
EQUIPMENT LIFTING DEVICES SUCH AS CHAIN, LIFTING EYES, HOOKS, ETC.,
MUST BE APPROVED BY LOCAL, STATE, OR FEDERAL SAFETY CODES.
HOIST AND CRANES MUST BE ADEQUATELY SIZED TO LIFT RATED LOADS.
FAILURE TO USE APPROVED LIFTING DEVICES MAY RESULT IN INJURY.
ENSURE THAT THE BYPASS LINE IS DIRECTED BACK INTO THE WET-WELL OR TANK
TO PREVENT HAZARDOUS SPILLS AS SOME LEAKING (1 TO 5 GALLONS [3.8 TO 19
LITERS] PER MINUTE) WILL OCCUR WHEN THE VALVE IS IN THE FULL-CLOSED
POSITION.
WHEN CHECKING ALIGNMENT YOU MUST FIRST DISCONNECT THE POWER
SOURCE.