Trillium WSP-6, Installation, Operation & Maintenance Instructions Manual, Page: 37 / 73

WSP™
DATA SHEET WSP™ SELF-PRIMER PUMPS WSP-D300_6
Rev. 3 01/09/20
© 2019 The Factory
37
REGULARLY OBSERVE THE CONDITION OF THE BEARING LUBRICANT FOR SIGNS
OF RUST OR MOISTURE, ESPECIALLY IN AREAS WHERE VARYING HOT AND COLD
TEMPERATURES ARE TYPICAL.
When operating the pump during cold weather, contact a lubricant supplier or
the factory for the recommended oil viscosity.
C. Power Source
Contact your local power source representative, or refer to the documentation
supplied with your power source for power requirements and
recommendations.
VII.
TROUBLESHOOTING
Adhere to all documented SAFETY procedures and follow safety information on all
labels, decals and tags affixed to the pump before any attempts to open or maintain
your WSP™ Self-Primer pump.
NO PERSON SHOULD ATTEMPT TO OPEN OR SERVICE THIS PUMP BEFORE
BECOMING THOROUGHLY FAMILIAR WITH ALL THE PROCEDURES OUTLINED
IN THIS MANUAL.
1. PLEASE STUDY THESE INSTRUCTIONS CAREFULLY.
2. WHEN PERFORMING EQUIPMENT MAINTENANCE, THE EQUIPMENT
ELECTRICAL SERVICE MUST BE LOCKED OUT WITH AN APPROVED
LOCKOUT AND KEY.
3. IF THE PUMP HAS OVERHEATED, ALLOW SUFFICIENT TIME FOR THE
PUMP TO COMPLETELY COOL BEFORE ATTEMPTING TO OPEN OR
SERVICE THE PUMP.
4. CAREFULLY CHECK THE TEMPERATURES BEFORE OPENING ANY
COVERS, PLATES, OR PLUGS.
5. CLOSE THE SUCTION AND DISCHARGE VALVES.
6. CAREFULLY AND SLOWLY VENT THE PUMP.
7. DRAIN THE PUMP.