WSP™
DATA SHEET
WSP™ SELF-PRIMER PUMPS
WSP-D300_10
Rev. 3
01/09/20
© 2019 The Factory
61
Bearings are nearing the point of failure when there is a sudden rise in bearing
temperature. Check for adequate viscosity of the bearing lubricant and be sure it is
at the appropriate level as noted in Section VI, LUBRICATION. Incorrect positioning
of the shaft can cause overheating of the bearings. Too much vibration can also
cause the bearings to overheat.
During initial pump start-up, the bearings may seem to operate at higher than normal
temperatures, however, continuing pump operation should reduce the temperatures
to normal operating range.
THIS SPACE INTENTIONALLY LEFT BLANK
Summary of Contents for 10-WSP
