L35 Series Install Guide
Page 6 of 20
TRIATEK® Lighting • 1025 Cobb Place Blvd. Suite 100 Kennesaw, GA 30144 • 800-241-9173 • www.triateklighting.com
11/30/2004
Due to continuous product improvement, TRIATEK Lighting reserves the right to change product specifi cations without notice.
Mounting the L35 Series Enclosure
1. Knockout Holes for high and low voltage conduit connections.
Figure 2
illustrates areas in the L35 Series enclosure where conduit holes for high and low
voltage wiring can be made.
a. Remove the interior.
If the panel was shipped with electronics installed, remove
the interior with electronics until all holes for conduit are punched and all metal
shavings are removed. Metal shavings from drilling could lodge in the electronic
components and cause damage.
The interior is held to the enclosure by four fl ange nuts. See Figure 3 below. Re-
move the interior and place it away from any work area before drilling holes for
conduit.
2. Mount the enclosure with anchors and screws according to Figure 3.
Figure 3 illustrates the location of the panel mounting holes. The top two mount-
ing holes of the panel enclosure are keyhole shaped so you can slide the unit over
mounting screws, avoiding the need to hold the unit while trying to secure the
mounting screws. Use wall anchors capable of supporting more than 80 pounds
(60 relay unit).
Installing the L35 Series
Mounting holes
(four total)
Interior fl ange
nuts (four total)
Figure 3
High Voltage
Conduit
High Voltage
Conduit
High Voltage Conduit
High Voltage
Conduit
High Voltage
Conduit
Low Voltage
Conduit
Figure 2
