L35 Series Install Guide
Page 18 of 20
TRIATEK® Lighting • 1025 Cobb Place Blvd. Suite 100 Kennesaw, GA 30144 • 800-241-9173 • www.triateklighting.com
11/30/2004
Due to continuous product improvement, TRIATEK Lighting reserves the right to change product specifi cations without notice.
Installing the DDN Module
The DDN Module for the L35 Series (Cat# DDN-L35) mounts to the back side the
hinged plate upon which the LMB is mounted. See Figure 29 for its location. The
DDN module communicates with the LMB through a ribbon cable, and it receives
its power from the LMB through a 2-wire connection. The DDN Module comes with
four mounting screws, one ribbon cable, and two power wires. See Figure 26 for
displayed parts.
1. Disconnect power.
Refer to Figure 4 on page 7 for power connection location.
Remove power by lifting the terminal block from the power terminals.
2. Remove LMB.
Remove the LMB by removing the six screws shown in Figure 27.
3. Open hinged backplate to locate the mounting position for the DDN.
Open
the hinged backplate by unscrewing the two thumb screws. They are located just
above the LMB.
4. Mount the DDN on the four mounting standoffs of the backplate.
See Figure
28.
5. Connect ribbon cable to DDN.
Close the hinged backplate to view the DDN
socket for the ribbon cable through square opening of the backplate. Connect the
cable, and then fold the ribbon cable to fi t between LMB and its plate as shown in
Figure 30.
Figure 28
Figure 29
Figure 26
Ribbon Cable
Mounting Screws
DDN-L35
LMB Highlighted
Mounting Screws
Figure 27
Power wires not shown.
