TRENDnet TWG-431BR, User Manual, Page: 7 / 93

© Copyright 2019 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TWG-431BR
4
LED Indicators
LED Description
Power
Solid Green – Device is ready and receiving power.
Off – Device is not powered or not ready.
Status Refer to USB mode section for functionality.
Storage Refer to USB mode section for functionality.
Gigabit Ports 1-5
LED LED r
Solid Green
– Port is connected at 10Mbps/100Mbps/1Gbps
link speed.
Blinking Green - Data activity/transmission on port.
Off – Port is disconnected or no link.
Port/Button Description
Ports/Buttons Description
RJ-45 Console
Port Using the included RJ-45 to RS-232 console cable, this
interface provides console/terminal (command line interface)
access to the device for management and troubleshooting
purposes.
Terminal Settings:
Baud: 57600 / Data: 8 / Stop: 1 / Parity: None / Flow: None
USB 3.0 Port Allows for an optional USB storage device (flash drive,
external HDD, etc.) to be connected and used for
configuration backup and export logging. (FAT32/NTFS
format only)
Gigabit Ports 1-5 By default, port 1 is configured as the LAN port and ports 2-5
are configured as WAN ports.
The ports can operate in two modes, 1 x LAN / 4 x WAN or 4 x
LAN / 1 x WAN.
By default, management access to the GUI and command line
interface via default LAN IP address: 192.168.10.1 /
255.255.255.0
The WAN port(s) connect your ISP(s) equipment for Internet
connectivity such as modem. By default, WAN1 (port 2) is
configured as the primary WAN interface and all WAN
interfaces are configured in load balance mode.
Reset Button Resets device to factory defaults. Using a paperclip, push and
hold the reset button for 15 seconds and release to reset the
device to factory defaults.
Power Port Connects the included power adapter to supply device
power.
On(-)/Off(o)
Power Switch Turns the device power On(-) or Off(o).