TRENDnet TWG-431BR, User Manual, Page: 40 / 93

© Copyright 2019 TRENDnet. All Rights Reserved.
32
TRENDnet User’s Guide
TWG-431BR
IM/P2P application filtering
Advanced > Access Control
You can deny access to a list of predefined IM/P2P applications outbound and filter by
MAC and/or IP address. You can check the current MAC addresses of devices connected
to your router under System > VLAN Setup > DHCP Server under the DHCP leases
section. You can also lock the IP address assigned to specific devices connected to your
router by
adding static DHCP leases or reservations . The access control section can also
be used to filter other outbound traffic by IP address, URL/keyword filter, and IM/P2P
applications.
1. Log into your router management page (see “ Access your router management page ”
on page 7).
2. Click on Advanced and click on Access Control .
3. Review the settings below.
•
Active – Select Enable to enable the access control rule.
•
Comment – Enter the name or description for the access control rule.
•
Protocol – Click the drop-down list to select the protocol for the service to
filter: ANY, TCP, UDP, ICMP , Content Filter, Domain Filter, IP P2P, or IM. Select
IP P2P or IM to select from a list of predefined applications.
•
Schedule – Allows you to select a schedule when the access control rule should
be enabled or disabled.
•
MAC Address – Enter the MAC address you would like to filter or deny traffic
and click Add to add to the list. ( e.g. a1:b2:c3:d4:e5:f6)
Note: You can filter by MAC address or IP address.
•
Local IP Address – Enter the IP address range to apply the access control rule.
(ex.: 192.168.10.20 – 192.168.10.30)
•
Local Port – Enter the source/local port. (Optional for IP P2P/IM)
•
Comment – Enter the name or description for the access control rule.
•
Destination IP Address – Enter the destination IP address range for the access
control rule. If left empty, this means any. (ex.: 10.10.10.20 – 10.10.10.30)
•
Destination Port – Enter the destination port. (Optional for IP P2P/IM)
•
Interface – Click the drop-down to select the local interface to apply the access
control rule.
•
IP/P2P or IM Setup – Select from the list of predefined P2P/IM applications to
apply the access control rule.