TRENDnet TV-IP200W, User Manual, Page: 116 / 145

115
required depends on the operation of your Wireless Internet
Camera. It depends on which ad-hoc mode is supported by your
wireless card driver on the PC/Notebook. Some driver supports
both modes, however, some driver support only one of the modes.
The names of each ad-hoc mode may not be consistent between
each wireless card vendor therefore you may need to try each of
the ad-hoc mode (802.11 mode and proprietary mode) and select
the mode that can communicate with each other.
Under infrastructure mode make sure the ESS-ID on the
PC/Notebook and the Wireless Internet Camera must match with
the Access Point’s ESS-ID.
Q: Why does the Wireless Internet Camera work locally but not
externally?
A1: Might be caused from the firewall protection. Need to check
the Internet firewall with your system administrator.
A2: The default router setting might be a possible reason. Need
to double check if the configuration of the default router settings
is required.
Q: Why does a series of broad vertical white line appears
through out the image?
A: A likely issue is that the CMOS sensor becomes overloaded
when the light source is too bright such as direct exposure to
sunlight or halogen light. You need to reposition the Wireless
Internet Camera into a more shaded area immediately as this will
damage the CMOS sensor.