TRENDnet TS-D40G, User Manual

Page: 10 / 42

Page 6
Installation and Setup
Requirements
? ?
Ethernet Network employing 10BaseT or 100BaseTX.
? ?
TCP/IP protocol.
LAN Installation
1. Connect Network Cable
? ?
Use the RJ45 socket to connect the Disk Server to your Hub.
? ?
The Disk Server will auto-configure for 10BaseT or 100BaseTX, and full or half
duplex.
2. Connect Printer
? ?
If you wish to share a printer, use a standard printer cable to connect the printer
to the Disk Server's parallel port.
3. Connect Power
? ?
Connect the supplied power adapter to a power outlet and the Disk Server.
? ?
Press and release the rear-mounted power switch to begin the start -up proce-
dure.
4. Check the boot process
? ?
During the self-test (2 or 3 seconds), ALL of the LEDs will be ON.
? ?
During the boot process, the Ready, Error and Disk Full LEDs will be ON.
? ?
Once the boot process is completed, the Ready LED should be ON and the Er-
ror LED should be OFF. If the Error LED stays On, there is a hardware problem.
Repeated beeps also indicate a failure to boot correctly.
2