TRENDnet TS-D40G, User Manual

Page: 7 / 42

Page 3
Figure 1: Disk Server Rear Panel
Power Switch This is a spring-loaded "Soft Switch".
If Off, press once to turn On.
If On, press once to start the Disk
Shutdown sequence.
During Shutdown , the Ready LEDs will blink.
Power Input Connect the supplied power adapter here.
Reset IP Button
(IP/Password) If the Disk Server's IP Address or password is lost, press and
release this button. The Disk Server will beep once to indi-
cate the reset has o ccurred.
The Disk Server password will be cleared, and its IP Address
set to the default value of 192.168.0.2, with a Network Mask
of 255.255.255.0
You can then connect t o the Disk Server and set the correct
IP Address and password.
Uplink Button If connecting directly to a PC or Macintosh via Ethernet,
depress this button.
For normal operation (connecting to a hub), this button
should be UP.
10/100BaseTX
connector Use this to connect the Disk Server to your 10BaseT or
100BaseTX hub.
100BaseTX LED
(amber) This will be ON if the 10/100BaseTX connector is using
100BaseTX.
10BaseT LED
(green) This will be ON if the 10/100BaseTX connector is using
10BaseT.
Printer Port Standard parallel printer port. A printer connected here
becomes a "network printer".