TRENDnet TEW-721BRM, User Manual, Page: 43 / 64

© Copyright 2014 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-721BRM
40
another network may have 192.168.20.x IP addressing and because the IP addressing of
these two networks are different, they are separate networks. In order to communicate
between the two separate networks, static routing needs to be configured. Below is an
example diagram where routing is needed for devices and computers on your network
to access the other network.
Note: Configuring this feature assumes that you have some general networking
knowledge.
1. Log into your router management page (see “Access your router management page”
on page 22 ).
2. Click on Advanced , and click on Static Route .
3. Review the settings and click Apply to save settings.

Rule Enable: Select whether to enable or disable the rule.

Forwarding Policy Option: Select whether to enable or disable routing.

Rule Name: Enter desired rule name.

Source IP: Enter the source IP address.

Source SubMask: Enter the source subnet mask.

Gateway: Enter the gateway IP address.

Destination IP: Enter the destination IP address.
Enable dynamic routing on your router
Advanced > RIP Settings
You may want to setup your router to route computers or devices on your network to
other local networks through other routers. If other routers support dynamic routing
such as RIP (Routing Information Protocol), you can enable this feature on your router
to automatically learn the required routes to reach those networks. It is required that
the same dynamic routing protocol and version is also enabled on the other routers in
order your router and the other routers to exchange information about the network.
Note: Configuring this feature assumes that you have some general networking
knowledge.
1. Log into your router management page (see “Access your router management page”
on page 22 ).
2. Click on Configuration at the top of the page, click on Advanced , and click on RIP
Setting.