10
Figure 2-10
ZPHA device to IPS device connection diagram (copper)
NOTE:
You must connect all cables according to segment. All IPS/TPS device segment
ports should be connected to the ports of one segment on the ZPHA device.
Connect power to the ZPHA device
1.
Ensure that all ZPHA device network cables are connected to the IPS/TPS device and that
traffic is passing through the ZPHA device. If traffic is not passing, you might need to use a
crossover cable instead of a straight cable for one of the network connections. See
cable installation” on page 13
2.
After you confirm that traffic is passing through the ZPHA device, turn on the IPS/TPS device.
3.
When the IPS/TPS device has completed booting, connect the nonstandard USB cable from the
IPS/TPS device to the ZPHA device. The ZPHA device receives power, lighting the Status LED
green. See the following diagram.
