ZPHA Installation Guide
11
WARNING!
Do not connect the USB cable until the IPS/TPS device is completely turned
on.
If you connect the USB cable before you turn on the device, network traffic halts
until
the IPS/TPS device is fully operational.
Figure 2-11
USB-type connection
Non-modular ZPHA device installation
1.
After unpacking the ZPHA device, install the device into the rack. The ZPHA device must be
located close to the IPS/TPS device to be networked to it.
NOTE:
Mount the ZPHA device in a standard 19- or 23-inch rack. The vertical hole spacing
on the rack rails must meet standard EIA-310-C requirements, which call for a one inch (2.54
cm) spacing.
2.
Connect the RJ-45 copper cables to route network traffic through the ZPHA device to the
IPS/TPS device:
•
Connect a cable from port A of the IPS/TPS device to port A of the ZPHA device segment.
•
Connect a cable from port B of the IPS/TPS device to port B of the ZPHA device segment.
3.
Connect the RJ-45 copper cables to route traffic through the ZPHA device ports to your
network:
•
Connect the cable for incoming traffic to port NET A on the ZPHA device.
•
Connect the cable for outgoing traffic to port NET B on the ZPHA device.
See the following diagram.
