Optional
Equipment
(for qualified installers only)
55
© Travis Industries
4101028
100-01255_000
Installation
WARNING
:
Make sure power to the stove has been shut off prior to installation.
NOTE
:
Refer to the wiring diagram on page 54 while making wiring harness connections.
1
Loosen the bottom panel attachment screws (there are two on each side see Figure 1). Slide the
bottom panel back and place it below the stove (see Figure 2). This allows for access to the controls
under the stove. NOTE: The ground wire may be disconnected to allow the panel to rest against the
ground. Make sure to re-connect this wire.
Figure 1
Figure 2
2
Remove the four screws holding the control panel to the front of the stove (see Figure 3). Carefully
remove the control panel, making sure you do not disconnect any wiring (see Figure 4).
NOTE
: Remove the battery trays before removing the control panel.
WARNING
: Take care to prevent scratching the control panel door (use cardboard
or paper).
Figure 3
Figure 4
