36
Operation
© Travis Industries
4101028
100-01255_000
Accent Light
This stove has a built-in accent light
that may be turned on and off and
dimmed to your preference. Turn
the knob to achieve the desired light
output.
ACCENT LIGHT
OFF
HIGH
LOW
Adjusting the Optional Blower Speed
The blower helps transfer heat from the heater into the room. It will not turn on until the heater is up to
temperature (approximately 15 minutes after starting). See the illustration below for instructions on
adjusting the blower speed.
NOTE:
With the rear burner off (comfort control), the heater may not become hot enough for the
blower to turn on.
BLOWER
OFF
HIGH
LOW
Continuous Pilot / GreenSmart™ Pilot Switch
This stove may run with the pilot continuously running or in GreenSmart
(intermittent) mode. For most homeowners, the GreenSmart mode is
preferred (this saves fuel, doesn’t give off un-needed heat). However, in
some situations the homeowner may prefer to switch the stove to
continuous pilot. The most typical reasons for switching to continuous
pilot are:
CONTINUOUS
PILOT
GREEN SMART
PILOT
•
Very Cold Conditions – in very cold conditions you may notice that the burner does not light quickly,
and the flames lift off the burner. If this is situation, we recommend you switch to continuous pilot.
This will create a slight draft in the vent, allowing for the burner to light quickly and draft correctly.
•
Excessive Condensation on Glass After Startup – certain installations may encounter excessive
fogging on the window after stuartup (not just the first time the stove was started). This is an
aesthetic condition that may be remedied by switching the stove to continuous pilot.
•
Cold Glass or Stove Front – in very cold conditions you may notice that the stove front and glass
become very cold. To remedy this, switch the stove to continuous pilot.
•
Frequent On / Off Operation – if you are frequently turning the stove on and off, you may wish to
leave it in continuous pilot. This allows the burner to turn on more quickly, without pilot ignition delay.
