Page
8
3.4
Electric connection of the Travel Vision R6 ®
The system is connected with 2 coaxial cables. The long coaxial cable is mounted between the antenna unit
located outside and the power inserter located inside. The power inserter is connected to your receiver by means
of the short coaxial cable (receiver is not included).
The Travel Vision R6 ® operates on 24 volt. The required 24 volt is supplied by the power inserter with 12V power
adapter.
By default, The Travel Vision R6 ® is suited for 1 receiver with unlimited channel reception from the chosen
satellite.
Connection procedure:
Firmly press the F-connector of the 15 mtrcoaxial cable over the
connector located on the bottom of the dish unit, so that the rubber is
indented, and hand-tighten it.
Press the F-connector on the other end of the 15 mtr coaxial cable
over the connector of the power inserter (indicated with “Antenna
R6”), so that the rubber is indented, and hand-tighten it.
Connect the short coaxial cable between the connector of the power
inserter (indicated with “Receiver”) and the “Antenna In” connector
of
your receiver, and hand -tighten both items.
Insert the power adapted jack plug (round plug) in the 24V port of
the power inserter (indicated with “Power-in 24V”) and insert the
power plug of the power adapter in a 230V wall outlet.
Switch on your satellite receiver to provide the LNB with power.
The system is now ready for use.
R6
Coax
Power Inserter
Coax
Receiver
Cable
Television
