2. uring searching for the satellite
show the following message:
This indicates that the system has found the GPS location and that the position of the
has to be adjusted as shown on the display. If you do not adjust the LNB
system may not receive a satellite signal.
Turn the LNB and bracket to
searching.
3. When the system finds a satellite with the
system concludes it has not found the selected satellite
will be shown:
The system will automatically resume searching for the selected satellite.
3.7
Removing the control module
A release pin is located on the bottom of the control module. Pr
Remark:
The control module is splash-proof so that you ca
that you remove the control module
water damage.
earching for the satellite with no GPS location, the system could suddenly stop searching and
the following message:
ROTATE LNB --
AND PRESS START
This indicates that the system has found the GPS location and that the position of the
has to be adjusted as shown on the display. If you do not adjust the LNB and bracket
a satellite signal.
to the correct position and press the Start button (1) the system will resume
When the system finds a satellite with the correct characteristics, the dish will stop rotating. But if the
system concludes it has not found the selected satellite after the internal check, the following message
ASTRA 1 19.2 °
Incorrect sat.
The system will automatically resume searching for the selected satellite.
the control module
the bottom of the control module. Press this release pin to remove
The control module is unlocked after the release pen is pressed.
Carefully remove the control module by pulling it to the right. Do this
gently to ensure that the current alignment of the dish is not altered.
proof so that you can align the system when it is raining
the control module following each alignment of the system to prevent theft and possible
page 13
suddenly stop searching and
This indicates that the system has found the GPS location and that the position of the LNB and bracket
and bracket position, the
the system will resume
characteristics, the dish will stop rotating. But if the
, the following message
ess this release pin to remove the control module.
control module is unlocked after the release pen is pressed.
the control module by pulling it to the right. Do this
ensure that the current alignment of the dish is not altered.
n align the system when it is raining. We recommend
to prevent theft and possible
