Page
16
7.3
Satellite found, but not all channels
Check whether your subscription or smart cart is still valid.
7.4
Error No 24V connected:
The AC power adapter is probably not connected.
The PI inserter may be coonected the wrong way, Check all connectors and switch power off and back
on. Reinstall the control module. See also 8.2 troubleshooting
7.5
Error Voltage Low:
The voltage is too low for system to operate.
If you use the external satellite connector in your motor home or caravan: Connect the supplied 15 mtr
coaxial cable directly to the receiver and see if the system works. See also 8.2 troubleshooting
7.6
Error during software update:
Repeat the software update procedure
7.7
Error during software update:
Check if the software has been correctly stored on the USB flash drive.
7.8
Error during software update:
Insert the USB flash drive once more.
7.9
Error messages: calibration failed, error azimuth adjustment, error elevation adjustment
Check that there are no obstructions which hinder the rotation or alignment of the dish. Remove the
control module from the antenna unit and reinsert it again.
ERROR:
No 24V connected
ERROR:
Voltage low
E:ERROR DURING
UPGRADE
E:FIRMWARE NOT
FOUND
E:USB DISK NOT
FOUND
ERROR DURING
CALIBRATING
ERROR AZIMUTH
ADJUSTMENT
ERROR ELEVATION
ADJUSTMENT