1800 816 277
www.tti.com.au
25
FloodRite
™
Product HandBook
The pairing process can be undertaken on site as follows:
NOTE! Check that the batteries in the remote control unit are in good
condition. Pairing with low batteries may indicate that pairing was
successful but may not work, in which case the paring process will need to
be repeated.
1. On the control box, turn the on-off switch to OFF, then remove the cover of the remote transmitter
module found on the rear of control box.
2. Lift the pairing jumper out of its holder and insert it into the position shown at Figure 12.
3. Simultaneously press the DRIBBLE button and the OPTION button. The centre LED will illuminate,
indicating the remote control unit is now ready for pairing with the control box.
4. Within 10 seconds of the LED illuminating, turn the on-off switch on the control box to ON.
5. The remote control unit will confirm the download of data is complete when the centre LED flashes eight
times. The control box’s LED display will flash Po-Id.
6. Turn the control box switch to OFF, remove the pairing jumper and return it to its jumper rest position.
The pairing process is now complete.
Figure 12 – Control Box / Remote Control Unit Pairing